American Fibertek SM24p-PoE Manuel d'instructions télécharger pdf (Page 60)

User Manual

Rev.A1

1-Mar-11

Parameter description:

Enable Jumbo Frames:

This function support jumbo frames of up to 12.2KB, Just tick the check

box () to enable it.

Default: disable

Perfect Reach/Power Saving Mode:

This function supports Power Saving and perfect Reach, Just select with

the Full/ Link-up/ Link-down/ Disable

Default: disable

Power Saving:

The parameter will enable or disable to verify switches have the ability to

consider the length of any Ethernet cable connected for adjustment of

power usage accordingly. Shorter lengths require less power. link-down

mode removes power for each port that does not have a device

attached.

Default: Disable.

Link:

Show link status of this port.

Mode:

Set the speed and duplex of the port. If the media is 1Gbps fiber, there

are three modes to choose: Auto Speed, 1000 Full and Disable. If the

media is TP, the Speed/Duplex is comprised of the combination of speed

mode, 10/100/1000Mbps, and duplex mode, full duplex and half duplex.

The following table summarized the function the media supports.

Media type NWay Speed Duplex

1000M TP ON/OFF 10/100/1000M Full for all, Half for 10/100

1000M Fiber ON/OFF 1000M Full

In Auto Speed mode, no default value. In Forced mode, default value

depends on your setting.

Flow Control:

You can Just tick the check box () to enable flow control. If flow control

is set Enable, both parties can send PAUSE frame to the transmitting

device(s) if the receiving port is too busy to handle. When it is set

Disable, there will be no flow control in the port. It drops the packet if too

much to handle.

Default: Disable

Flow Control status:

To display the Flow control status.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 124 125

Pas de commentaire

American Fibertek SM24p-PoE Manuel d'instructions Page 60