American Fibertek SM24p-PoE Manuel d'instructions télécharger pdf (Page 119)

User Manual

Rev.A1

1-Mar-11

111

5. Maintenance

5-1. Resolving No Link Condition

The possible causes for a no link LED status are as follows:

 The attached device is not powered on

 The cable may not be the correct type or is faulty

 The installed building premise cable is faulty

 The port may be faulty

5-2. Q&A

1. Computer A can connect to Computer B, but cannot connect to Computer C

through the 24-Port Gigabit Managed PoE Switch.

 The network device of Computer C may fail to work. Please check the

link/act status of Computer C on the LED indicator. Try another network

device on this connection.

 The network configuration of Computer C may be something wrong. Please

verify the network configuration on Computer C.

2. The uplink connection function fails to work.

 The connection ports on another must be connection ports. Please check if

connection ports are used on that 24-Port Gigabit Managed PoE Switch.

 Please check the uplink setup of the 24-Port Gigabit Managed PoE Switch to

verify the uplink function is enabled.

3. The console interface cannot appear on the console port connection.

 24-Port Gigabit Managed PoE Switch has no console port, so you cannot

use console interface to connect with 24-Port Gigabit Managed PoE Switch.

4. How to configure the 24-Port Gigabit Managed Switch.

 User can use IE browser program in window series of computer to control

the Managed functions in 24-Port Gigabit Managed PoE Switch. First,

choose any port in 24-Port Gigabit Managed PoE Switch. Then, use IE and

type default IP address, 192.168.1.77, to connect to 24 Gigabit with RJ45

network line. Finally, the login screen will appear at once.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 125

Pas de commentaire

American Fibertek SM24p-PoE Manuel d'instructions Page 119