American Fibertek SM24p-PoE Manuel d'instructions télécharger pdf (Page 17)

User Manual

Rev.A1

1-Mar-11

2. Installation

2-1. Starting 24-Port Gigabit Managed PoE Switch

This section will give users a quick start for:

Hardware and Cable Installation

- Management Station Installation

- Software booting and configuration

2-1-1. Hardware and Cable Installation

First of all:

⇒ Wear a grounding device to avoid the damage from electrostatic discharge

⇒ Be sure that power switch is OFF before you insert the power cord to power

source

•

Installing Optional SFP Fiber Transceivers to the 24-Port Gigabit Managed PoE

Switch

Note: If you have no modules, please skip this section.

Fig. 2-1 Installation of Optional SFP Fibe

Transceive

• Connecting the SFP Module to the Chassis:

The optional SFP modules are hot swappable, so you can plug or unplug it

before or after powering on.

1. Verify that the SFP module is the right model and conforms to the chassis

2. Slide the module along the slot. Also be sure that the module is properly

seated against the slot socket/connector

3. Install the media cable for network connection

4. Repeat the above steps, as needed, for each module to be installed into

slot(s)

5. Have the power ON after the above procedures are done

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 124 125

Pas de commentaire

American Fibertek SM24p-PoE Manuel d'instructions Page 17